Yes, in two ways:
1. Load each G-code separately, position with OFFSET FROM 0,0 to a different spot in the material block, cut. Repeat. Re-zero the wire at start of each cut, or position relative to the previous cut.
2. (Not yet implemented) Batch nesting — upload several shapes and the tool packs them into the cheapest set of foam blocks. On the roadmap.
1. Load each G-code separately, position with OFFSET FROM 0,0 to a different spot in the material block, cut. Repeat. Re-zero the wire at start of each cut, or position relative to the previous cut.
2. (Not yet implemented) Batch nesting — upload several shapes and the tool packs them into the cheapest set of foam blocks. On the roadmap.