Real cuts, not renders

Foam cut on a real machine

Every shape on cncfoam.com is designed to be cut for real. These are genuine workshop photos of hot-wire cuts made on the FoamCube — architectural parts, mouldings, casting masters and the machine itself. No renders.

Безкоштовно · No signup · FluidNC + GRBL · Built by a real maker ↗

Відкрийте інструмент → Who built this

A batch of white EPS foam parts hot-wire cut on a FoamCube — a two-column balustrade, a finial, a Greek-key fret, gears and cylinders — on a workbench — A batch of foam architectural parts, hot-wire cut

Example foam cuts from the FoamCube

Several identical scroll profiles cut straight through a full pack of EPS polystyrene insulation board, with a cut foam flower beside it — Identical profiles cut through a whole pack of EPS board

A white foam pedestal with a curved saddle top and arched legs, cut in a simple 2-axis hot-wire pass, on an OSB workbench — Foam pedestal cut in a single 2-axis pass

A white EPS foam pagoda-lantern form cut on the FoamCube, used as a master pattern for a concrete mould, on a workbench — Foam master for a concrete casting mould

Lengths of decorative EPS crown and cornice moulding profiles (ogee and half-round) cut on the FoamCube, on a workbench — Hot-wire-cut crown & cornice moulding profiles

Several parallel bead and half-round moulding profiles cut from a thin EPS sheet on the FoamCube machine bed — Bead moulding profiles cut from a thin EPS sheet

Flat 2-axis hot-wire-cut foam lettering, backlit with warm light, on the machine bed — Flat 2-axis cut foam lettering

An early FoamCube cut: a white foam architectural column capital on the machine bed, with the maker and the RAMPS controller electronics in the workshop behind — One of the first FoamCube cuts — a column capital

The FoamCube 4-axis CNC hot-wire foam cutter — a white aluminium-frame machine with finished foam cuts on its bed: turned chess-piece columns, a square spiral block, a gear and a flame — The FoamCube 4-axis machine with finished cuts

A grey plaster-of-paris finial cast from a hot-wire-cut foam mould, in a makerspace — Plaster-of-paris finial cast from a foam mould

A collection of white EPS foam parts cut on a CNC hot-wire machine — a turned balustrade, finials, gears and blocks — under the cncfoam.com banner — CNC hot-wire-cut foam parts: balustrade, finials, gears

Want to make your own? Open the free tool, drop an SVG/DXF or pick a generator, preview in 3D, and stream the G-code to your FluidNC or GRBL machine. See how it compares to FoamCut.